1. Working principle of converter steelmaking
Converter steelmaking is a steelmaking method in which air or oxygen is blown into molten iron to rapidly oxidize carbon, manganese, silicon, phosphorus, sulfur, and other elements in the molten iron, and the heat released during oxidation is used to heat up without additional heating. Converter can be divided into three types according to the blowing position: bottom blown converter, side blown converter, and top blown converter. According to the acidity and alkalinity of refractory materials for furnace lining, they can also be divided into acidic converter and alkaline converter. In the early stage of converter steelmaking, air is used for blowing, as the nitrogen contained in the air is neither a combustion supporting gas nor participates in chemical reactions. Almost all of it escapes from the furnace taphole and also takes away a large amount of heat energy. The remaining nitrogen in the steel can also damage its quality. Since the adoption of oxygen blown method, the shortcomings of limited steel grades and low quality in converter smelting have been overcome. The current smelting quality and variety of oxygen top-blown converter have caught up with open hearth, and some properties even exceed open hearth. The original advantages of converter steel, such as low investment, fast construction, high adaptability to raw materials, and high productivity, have been fully utilized. Therefore, converter steelmaking is a very promising steelmaking method. From the situation in various countries around the world, converter steelmaking has a great potential to replace open hearth steelmaking. According to statistics, in 1960, the steel produced by oxygen top-blown converter steelmaking accounted for only 4% of the world's steel production, but by 1969 it had risen to 37%, and by 1972 it had risen to 53%, far exceeding the production of open hearth steel. At present, China mainly uses oxygen top-blown (alkaline) converters and oxygen side-blown (alkaline) converters.
2. The production process of oxygen top-blown converter
The exterior of the oxygen top-blown converter is made of steel plate and lined with alkaline refractory bricks. The main raw material for steelmaking is molten iron, which also uses a portion of scrap steel (or iron ore) as a coolant, as well as slag making materials such as lime and fluorite (CaF2) added to remove sulfur and phosphorus. Deoxidizers such as manganese iron, silicon iron, or aluminum are also used for deoxidation. The steelmaking process can be roughly divided into three stages: loading, blowing, and deoxidation. First, some scrap steel and iron ore are loaded, followed by molten iron with a temperature of about 1200-1300 degree . Then, an oxygen lance is inserted into the furnace spout to blow oxygen, rapidly oxidizing carbon, silicon, manganese, and other elements in the molten iron, while releasing a large amount of heat to melt the scrap steel and iron ore. During the oxygen blowing process, slag making materials are also added to remove phosphorus and sulfur. After blowing oxygen for a certain period of time, carbon, silicon, manganese and other elements decrease to a certain range, stop blowing oxygen and extract the oxygen lance. If the temperature of the molten steel is too high at this time, add scrap steel for cooling. When the composition and temperature of the molten steel meet the requirements, steel can be produced. Deoxidizer is usually added to the molten steel ladle during steelmaking. The blowing time of a 300 ton converter is less than 20 minutes, including auxiliary time not exceeding 1 hour. Oxygen top-blown converter steelmaking has high output and good quality, and is a very promising steelmaking method. The production capacity of a converter is expressed in terms of the weight of molten iron that can be injected during each blowing process. For example, if 10 tons of molten iron can be injected during each blowing process, it is called a 10 ton converter.
